Quote Originally Posted by victor3ranger View Post
Is there a reason they are using polymer internals?? Other than weight savings I am not sure I would want the working parts inside the lower to be made if these.
If the insides were normal trigger parts I might be interested in playing with one.
I would assume but the internals are not the best. Went all mil-spec parts except pivot pins and replaced trigger with ALG single stage. Really nice trigger, no creep. Just a tad bit of stoning but all the edges were very clean. about 5 1/2lbs. NOT a match trigger, but for $45, a nice balance between a factory trigger and a triple digit match unit. Save the Jewell for a match rifle.