Extractor Spring Installation Tool
Brownells part # 080-685-130WB
#5 - 3.5MM (0.138") ROLL PIN HOLDER
l_080685130_1.jpg
As luck would have it I discovered this 3.5 mm roll pin holder works great for installing extractor springs. Just cut a small piece off of a 3.5mm o'ring, enough to fill the hole about 1/2 way on the punch.
The tool holds the extractor spring just right and prevents over compression and deformation of the spring while snapping it into the extractor.
Last edited by prepare; 04-19-22 at 03:29.
You won't outvote the corruption.
Sic Semper Tyrannis
Bookmarks