Need help from the brain trust here

[Iraqgunz]

I have yet to see properly Loctited screws come loose. With that said, should you need to remove it, heat works. With Rocksett you would need to submerge it in water.

Would rocksett not be equal or better for this job since it can handle higher heat than loctite?

[teksid]

It’s not my rifle so I’m not too concerned with durability. I don’t think my friend is either since he bought a $400 AR. He told me he bought it New a few years ago and only shot a few rounds through it because it stopped working. So I don’t ever see him running it hard. I will try to talk him into getting a better gas block or a better rifle, but I’m pretty sure he won’t heed my advice. I’m pretty sure it is an Oracle. The barrel was dimpled FWIW. I just tightened them down and used a lot of Red Loctite.

[teksid]

I have yet to see properly Loctited screws come loose. With that said, should you need to remove it, heat works. With Rocksett you would need to submerge it in water.

I’ve only owned Red loctite. I use it on Glock front sights and such. I’ve never used it on an AR beings that I prefer pinned gas blocks. I’ve never had an issue getting it off using heat.

[Iraqgunz]

Please read what I posted.

I’ve only owned Red loctite. I use it on Glock front sights and such. I’ve never used it on an AR beings that I prefer pinned gas blocks. I’ve never had an issue getting it off using heat.