Is this typical?
I just noticed so I checked my RRA NMA2 that I've fired 10x as many rounds thru and it is there as well though much less obvious.
About 200 rounds
Is this typical?
I just noticed so I checked my RRA NMA2 that I've fired 10x as many rounds thru and it is there as well though much less obvious.
About 200 rounds
Last edited by danpass; 08-15-13 at 22:19.
Dan Miami, FL
Hmmm …… well ok.
I just wonder why have this cutout in the upper for the cam pin if it is going to strike anyway ……
Cutout centered too far forward?
Last edited by danpass; 08-15-13 at 23:06.
Dan Miami, FL
It's settling in. Getting comfy.
What is your experience level with the AR15 FOW?
Owner/Instructor at Semper Paratus Arms
Facebook: https://www.facebook.com/SemperParatusArms/
Semper Paratus Arms AR15 Armorer Course http://www.semperparatusarms.com/cou...-registration/
M4C Misc. Training and Course Announcements- http://www.m4carbine.net/forumdisplay.php?f=141
Master Armorer/R&D at SIONICS Weapon Systems- http://sionicsweaponsystems.com
Just this and my A2. Self researched.
This one I built.
(As far as lube, I had wiped the area to get a better pic)
I had gone thru your single post on Inspection
Dan Miami, FL
Owner/Instructor at Semper Paratus Arms
Facebook: https://www.facebook.com/SemperParatusArms/
Semper Paratus Arms AR15 Armorer Course http://www.semperparatusarms.com/cou...-registration/
M4C Misc. Training and Course Announcements- http://www.m4carbine.net/forumdisplay.php?f=141
Master Armorer/R&D at SIONICS Weapon Systems- http://sionicsweaponsystems.com
Here is a good discussion related to cam pins
Cam-pin wear as a contributor to bolt failure?
https://www.m4carbine.net/showthread.php?t=134117
Last edited by Clint; 08-16-13 at 09:03.
Black River Tactical
BRT OPTIMUM Hammer Forged Chrome Lined Barrels - 11.5", 12.5", 14.5", 16"
BRT EZTUNE Preset Gas Tubes - PISTOL, CAR, MID, RIFLE
BRT Bolt Carrier Groups M4A1, M16 CHROME
BRT Covert Comps 5.56, 6X, 7.62
Bookmarks